Plasmacluster
AUTO
MANUAL
Fan Control
POLLEN
OFF
TIMER
DISPLAY
ON/OFF
POWER ON/OFF
FILTER RESET
CLEAN
ION CONTROL
OFF
AUTO
Plasmacluster Ion mode Selections
Auto
When pressed, the unit will switch between
Clean Mode and the Ion Control Mode auto-
matically depending on the amount of impuri-
ties in the air as detected by the dust sensor
and the odor sensor. Clean Mode will operate
for 1 minute when the Auto function is se-
lected.
Ion Control
When pressed, the unit will constantly oper-
ate in Ion Control Mode.
The Plasmacluster Ion Indicator Light is green.
Clean
When pressed, the unit will con-
stantly operate in the Clean Mode,
in which the same numbers of posi-
tive and negative ions are dis-
charged. The Plasmacluster Indica-
tor Light is blue.
Off
The generation of ions will cease
and the Plasmacluster Indicator
Light will go out.
E-14
REMOTE CONTROL OPERATION
OPERATION
Operations available with
the Remote Control
• AUTO
• MANUAL
• POLLEN
• OFF TIMER
• DISPLAY ON/OFF
Plasmacluster Ion mode
selections
• AUTO
• CLEAN
• ION CONTROL
• OFF
• When you press the POWER ON/OFF Button, a short
beep will sound and operation will start in AUTO Mode.
Transmitter
Filter Reset Button
When the Washable Active Car-
bon Filter is cleaned and
reinserted into the main unit,
press the Filter Reset Button with
a pointed instrument such as a
pen.
Pollen Mode Operation
Button
See Page E-12
Off Timer Button
The set time switches every time
the button is pressed as shown
below.
1 hour 4 hours
Cancel 8 hours
• The indicator light shows the re-
maining time.
POWER ON/OFF Button
To stop, press the POWER
ON/OFF Button again.
A long beep will sound and
operation will stop.
Auto (Fan Speed) Button
The fan speed switches au-
tomatically depending on the
amount of impurities in the air.
Manual (Fan Speed) Button
The fan speed can be
switched among Silent, Me-
dium, High and Max settings.
Display ON/OFF Button
Switches the Plasmacluster
Indicator Light and CLEAN-
SIGN Light either ON or OFF.
To Next Page
Loading...
