Sharp PN-V601 - Page 16

16
Welcome Center settings (Windows Vista only)
 ThesesettingsdonotapplytoWindowsXP/7.
Underdefaultsettings,the“WelcomeCenter”isdisplayedwhen
Windows Vista is started.
Clearthe“Runatstartup”checkbox,tostopthe“Welcome
Center”frombeingdisplayedwhenaprogramisdisplayedin
ProgramViewer.The“WelcomeCenter”willnotappearfromthe
nexttimethePCisstarted.
 If“WelcomeCenter”isclosedyoucandisplayitusing
either of the following methods.
•FromtheWindowsTaskbar,click[Start],[ControlPanel],
[SystemandMaintenance],andthen[WelcomeCenter].
 •FromtheWindowsTaskbar,click[Start],[AllPrograms],[Accessories],andthen[WelcomeCenter].
Screen saver settings
Disable the screen saver so that it does not display on the monitor when a program is displayed in Program
Viewer.
•If using Windows XP
1. Right-click on an empty area of the desktop, and from the menu that appears, click [Properties].
The[DisplayProperties]dialogboxwillappear.
2. Click the [Screen Saver] tab and select “(None)” from the
“Screen saver” list.
3. Click [OK].
Installing SHARP Digital Signage Software