Sharp PN-V601 - Setting the environment of the target PC

15
●Setting the environment of the target PC
Oncetheinstallationiscomplete,changethesettingsofthetargetPCbeforeusingthissoftware.A
descriptionisgivenbelow,usingWindowsXP/Vista/7asanexample.
Auto login settings
IfthetargetPCistobeusedwithoutanoperator,Windowsautologinshouldbeenabled.
If using Windows Vista, use the following procedure to enable auto login.
1. From the Windows Taskbar, click [Start], [All Programs], [Accessories], and then [Command
Prompt].
The[CommandPrompt]windowwillappear.
2. Type in “control userpasswords2” (without the inverted
commas) and push [Enter].
3. If the [User Account Control] window appears, click
[Continue].
The[UserAccounts]dialogboxwillappear.
4. Clear the “Users must enter a user name and password
to use this computer” check box.
5. Click [OK].
6. In the [Automatically Log On] window, enter a “User
Name” and “Password”, and click [OK].
7. Type in “exit” and then press [Enter].
Installing SHARP Digital Signage Software