Sharp PN-V601 - Page 64

64
Timetable Editor
2. Select the panel control command you want to use from
the “Command Name” and click
.
The[AddPanelControlCommandtoTimetable]dialogbox
will appear.
3. Set the “Time”.
Thisisthetimethatthecommandwillbeexecuted.
Specifytimesbetween00:00and24:00.
4. Click [OK].
The panel control command will be registered in the timetable
and the control command icons (Turn On Display:
, Turn
Off Display:
, Switch Input Source: , TV: ) will be
displayed to the right of the timetable.
 Commandsmayalsoberegisteredbydraggingthemfromthe“CommandName”tothe
“Timetable”.
5. Repeat steps 2 to 4 as necessary and set all the panel control commands that you want to execute
over the course of the day.
Creating a timetable