To Next PageTo Next Page
Need help?Do you have a question about the Sharp SC-7700CDH and is the answer not in the manual?
General| Power output | 60 watts per channel into 8Ω (stereo) |
|---|---|
| Frequency response | 10Hz - 100kHz (±1dB) |
| Total harmonic distortion | 0.008% (1kHz, 8 ohms) |
| Dimensions | 430 x 140 x 350mm |
| Weight | 10.2kg |
| Tuning range | FM, MW |
| Input sensitivity | 150mV (line) |
| Speaker load impedance | 8Ω to 16Ω |
General specifications of the unit.
Specifications related to the tuner functionality.
Specifications for the pre-amplifier inputs and outputs.
Specifications for the cassette tape deck.
Specifications for the CD player functionality.
General technical data of the unit.
Technical data for the tuner section.
Technical data for the pre-amplifier section.
Technical data for the cassette deck section.
Technical data for the CD player section.
General characteristics of the unit.
Characteristics related to the tuner functionality.
Characteristics for the pre-amplifier.
Characteristics of the cassette deck.
Characteristics of the CD player.
Cautions to avoid laser exposure during pickup service.
Safety measures for pickup replacement and adjustment.
Precautions for pickup replacement or adjustment.
List of parts for the remote control unit.
Buttons for tuner operation.
Buttons for CD player operation.
Parts list for the remote control.
Control buttons for the tuner.
Control buttons for the CD player.
Parts list for the remote control.
Control buttons for the tuner.
Control buttons for the CD player.
Precautions to follow during disassembly and reassembly.
Precautions to follow during disassembly and reassembly.
Adjustments for the mechanism section.
Adjustments for the deck section.
Adjustments for cassette playback sensitivity, azimuth, and speed.
Adjustments for the mechanism section.
Adjustments for the deck section.
Adjustments for cassette playback sensitivity, azimuth, and speed.
Adjustments for the mechanism section.
Adjustments for the deck section.
Adjustments for cassette playback sensitivity, azimuth, and speed.
Specifications for AM Intermediate Frequency.
Specifications for FM Intermediate Frequency.
Adjustment for FM auto scan DC voltage and distortion.
Adjustment for FM auto stop level.
MW Intermediate/High Frequency data.
UKW Intermediate Frequency data.
FM auto scan DC voltage and distortion data.
FM auto stop level data.
FM/RF AM (PO) frequency data.
FM Intermediate Frequency data.
FM auto scan DC voltage and distortion data.
FM auto stop level data.
Steps for preparing CD section adjustments.
Adjustment of the VCO free-run frequency.
Adjustment of tracking error balance.
Procedure for checking the HF output signal.
Adjustments for focus, tracking, and gain for the servo unit.
Preparation for adjustments in the CD section.
Adjustment of the voltage-controlled oscillator frequency.
Adjustment of tracking error balance.
Checking high-frequency output power.
Adjustments for focus, tracking, and gain for the servo unit.
Preparation for adjustments in the CD section.
Adjustment of VCO free-run frequency.
Adjustments for focus, alignment, and gain for the servo unit.
Explanation of resistor symbols and units.
Explanation of capacitor symbols and units.
Explanation of resistor symbols and units.
Explanation of capacitor symbols and units.
Explanation of resistor symbols and units.
Explanation of capacitor symbols and units.
List of replacement integrated circuits.
List of replacement transistors.
Lists of replacement capacitors, coils, diodes, resistors, etc.
List of replacement integrated circuits.
List of replacement transistors.
Lists of replacement capacitors, coils, diodes, resistors, etc.
List of replacement integrated circuits.
List of replacement transistors.
Lists of replacement capacitors, coils, diodes, resistors, etc.
