Sharp SF-1020 - Center Shift Adjustment; Label Attachment; A. Label Attachment

9. Center shift adjustment
There is basically no need to perform the center shift adjustment
because it is made when shipping. If the center should be shifted,
adjust in the following procedures.
Make a copy. If the center is shifted as shown in Fig. 1 or Fig. 2,
loosen the four screws which are fixing the cassette grip cabinet.
(Note) When fixing the cassette cabinet, the fixing screws and the
cabinet clearance a and b are in symmetry.
(1) Fig. 1
Move the cassette grip cabinet in direction A, tighten two fixing
screws (a) and tow fixing screws (b) in this sequence. Make a copy
again and check the center.
(2) Fig. 2
Move the cassette grip cabinet in direction B, tighten two fixing
screws (a) and tow fixing screws (b) in this sequence. Make a copy
again and check the center.
10. Label attachment
A. Label attachment
Attach the magnification ratio select label packed together with the
Operation manual to the position shown in the figure below.
• When attaching the label to the copier with the original cover.
• When attaching the label to the optional automatic original feeder
(SF-A15)
Section a
Direction A
Section a
Direction B
Section b Section b
[Reference figure]
Section b
Section a
[Fig.1]
Paper center line
Image center line (First image)
[Fig.2]
Paper center line
Ima
g
e center line
(
First ima
g
e
)
Magnification ratio select lable
Magnification ratio select lable
4 – 7