(Note for assembly 2)
When attaching the paper feed section roller ass’y, adjust so that the
paper feed roller clutch and the PS front roller ass’y clutch projection
face toward the paper feed side.
1-3. PS front roller ass’y
1 Remove the paper feed unit. (For the details, refer to the 1-1.)
2 Disengage the hook section of the front frame side bearing,
remove the connector on the rear frame side, and remove the PS
front roller ass’y from the paper feed frame.
1-4. Separation roller
1 Remove the paper feed unit and remove the separation roller.
1-5. Paper feed roller, take-up roller
1 Remove the paper feed roller, and remove the take-up roller.
2 Remove the roller holder, the stop ring, the bearing, and the paper
feed roller.
6 – 2
To Next Page
Loading...
