1
I
!
I
------
SF-7300
SF-7350
/
{
/
(
Tonercontrolsensorlevel adjustingpot
/
Level adjustingvoiume
\-
About200 degrees
NOTE: Do not rotatethe potmore than200 degrees w itw.11
be damaged.
(8)
Sb* turn pot counter clockwiseand stq when the toner
farnp~PL) justgoes out.
NOTE: Turningon the power with toner in the toner hopper
and the toner sensor not adjusted may affect the
toner concentratiorr.To achieve pr~r toner bvd
the above procedure to set up the TCS bvel must
be perfoti stadng withstep E.
F. Installingtoner
(1) Load toner in the toner hopper after the cornpbtiorrof the
tonercontrolsensor(TCS) bvd adjustment.
G.Confirmingthe modeltypeandlocalmode
program
(Checkmethod)
(1)
(2)
(3)
(4)
Executet=~ command79.
When thistest commandis executed, the modd type and the
bcal mode sew data currentiystored in the memo~ (see
the tabb bebw) are displayed, and the READY lamp turns
on.
You will now enter a twdigk number shown in h tabk
after the READY lamp turns ON. The
numbermust match
the modd type ad the local mode setdng.
Pushthe PRINT switchto storethe numberin the memory.
The READY lampgoes outa~er the numberis stored.
Push the CLEAR key twice to terminate the teat command
79.
L-
mode
Model
VP
Ld standards
number
00
Japan
02
SF-7300
Export
AB
Se&S
03
InchSetis
04
Japan
06
SF-7350
AB
SerbS
07
Export
Imh Wti$
H.Coronawirecleaning
a.
Main corona
(1) Turn the main power OFF.
(2) Open the hont cover and pull the main corona unit dowly
out.
(3) Hti the corona wirebetween the tipsof the coronacleaner,
and wipe the wire moving the cleaner in the directionindi-
cated on the coronahandle.
● Put a Iittb abohol on the ckaner ifthe coronawire is par-
ticuldydi~.
● Do not bend or pullthe wire.
k
J
(4) Push the main corona unit back into @ace and closes the
frontcover.
b.Transfercorona
(1)
Push down on the frame open bver to ~ the clam shell
mechanism.
(2) Wti the transfercorona unitstillinstal~, ckan the transfer
‘coronaW.rewith the providedcksner.
-—
2–5
.
To Next Page
Loading...
