Sharp SF-7700 - Page 9

SF-7700
SF–775O
5. Cleaning the corona wire
@
Clean the main mrona unti withthe Drovidedcleaner. and then
&install the main @ron,aunit in the bpy machine.
6. Local mode programming
Somemtrol programsmayk reviaedtomeetId wuirementa.
Use the test mmmands 79, and 78 to reprogram.
@ Testmmmand79. (Uaedtoaaagnthe modelandblveraion.)
Performthe followingmmmand ant to setupthe desiredmode:
c + P + o + P + ❑ +~+ h
(withthis, the previously
~rammed mode num~r is dis~ayed withthe ready lampturned
ON) +
❑+ a (enterthe desired~ digitmodenum~r) + _
(the new mode numbr is displayedand the ready tip goes out)
+ C (the teat mmmand is now cleared).
@ Liftthe u~r hdf release lever and ~n me ~py machine.
@ with the transfer arena unit
stilt i“st~l~, clean the transfer
mrona wire with the providedcleaner.
/
K
i
m
12 100V
*(us)
● Ctiof~
2
.=
sue~efwem
2
13
100V*
● swy -
~
(otherthanUS)
_tiOn isset
=
17 mvaarias
kl I
02
1,~oovsarias(us) \
Ramsrfr
-hti*aa.~and~R.
aradi@ayadhJapen.thayare
notuaadinotiar~.
2–6
. ..m