Sharp SMO1854DS - OPERATION PROCEDURE; Basic Operating Steps; Setting Power Level

11
3. Replace cooktop light
When replacing the cooktop light, make sure you allow
the cooktop lights to cool down and wear gloves to avoid
injury from the heat of the lamps.
1) Unplug the oven or turn off the power at the main
power supply.
2) Remove the screw from the light cover and lower the
cover until it stops.
3) Remove the screw of the LED Light secured to the
Cover and pull out connectors.
4) Replace with 1.0-watt LED light available from your
authorized dealer and secure with screw.
You can purchase LED cooktop light from
1-800-BE-SHARP.
5) Reverse the above steps for reassembly.
4. Replace oven light
When replacing the internal oven light, make sure you
allow oven light to cool down and wear gloves to avoid
injury from the heat of the lamp.
1) Unplug the oven or turn off the power at the main
power supply.
2) Remove the vent grille mounting 3 screws and open
the door.
3) Slide the grille air to the left, then pull it straight out.
4) Remove the charcoal filter, if present
5) Pull the hook a little and remove light cover.
6) Push the right hook holding the oven light to the right
side and remove the LED light.
7) Replace with 0.4-watt LED light available from your
authorized dealer.
You can purchase Oven Light from
1-800-BE-SHARP.
8) Reverse the above steps for reassembly.
LIGHT COVER BULB LIGHT
LIGHT COVER LED LIGHT
CHARCOAL FILTER