SSC3088AS
33
1. Remove the connector of the controlling harness from the steam
duct side and remove the harness of the sirocco motor (right) from
the controlling harness.
Steam duct
Connector of the
controlling harness
Harness of the sirocco
motor (right)
Sirocco motor (right)
2. Remove the steam duct cover from the steam duct and the MG air
supply guide. (9 screws and 3 claws)
Claw
Claw
Claw
Screw
（XETS740P10000）
Screw
（XETS740P12000）
Steam
duct
cover
MG air supply guide
Sirocco motor fastening screw
（XEPS740P40000）
Screw（XETS740P10000）
3. Remove the screw (1x) which fixes the sirocco motor (right) to the
steam duct.
4. Remove the sirocco (right) from the steam duct.
[21] Bottom plate cover
1. Rotate the main body so that the bottom plate faces upward.
2. Remove the screw which fastens the bottom plate cover to the bot-
tom plate.
Screw
Bottom plate cover
3. Remove the pump tube from the cord holder which is fitted on the
bottom plate cover.
Bottom
plate cover
Code
holder
Tube joint
Pump tube J
Pump tube E
4. Remove the cord holder from the bottom plate cover.
[22] bottom plate
1. Remove the side cover R, the side cover L, the exhaust cover and
the cabinet. [3] Reference
2. Remove the left/right reinforcing AG and the rear plate. [17] Refer-
ence
3. Remove the AC cord. [15] Reference
4. Remove the bottom plate cover. [21] Reference
5. Remove the pump tube J or the pump tube E from the tube joint.
6. Remove the harness from the tank SW.
7. Remove the harness from the the pump motor connector.
Pump tube J
Tube joint
Pump tube E
Connector of pump motor
Tank SW
8. Remove the screw (1x) which fixes the R hinge K and the L hinge K
onto the bottom plate.
9. Remove the screws (5x) which fasten the bottom plate to the front
plate of the oven DK.
10. Remove the screws (one each for the left and the right respectively)
which fix the bottom plate onto the heat insulating plate bottom..
To Next Page
Loading...
