SSC3088AS
34
Bottom plates
The circle mark is the position of the screw
Reference
When removing the bottom plate to replace the following parts, it is
necessary to remove the reinforcing AG and the rear plate.
●Relay board
●Fan motor ●Tube pump K or pump motor
●Drip pan SW ●Tank SW
In order to remove the bottom plate, first remove the screws (3 screws)
which fix the rear plate to the bottom plate. Then, remove the bottom
plate cover and remove the screw which fixes the bottom plate in the
above-stated sequence. Then, move the part where the end of the rear
plate covers the bottom plate to the rear of the product by about 2 mm
and you can remove the bottom plate.
Note: When moving the rear plate, take care not to deform the rear
plate.
Screw
Rear plate
To Next Page
Loading...
