SSC3088AS
36
1) Remove the exhaust duct from the oven DK and remove the hu-
midity sensor. ( Refer to 1. How to remove the humidity sensor)
2) Remove the screws (7x) which fix the exhaust duct top to the
exhaust duct bottom.
Lower
exhaust
duct
Screw
Screw
Upper exhaust duct
Lower
exhaust
duct
Upper exhaust duct
Screw
Screw
Screw
Screw
Upper exhaust duct
Lower
exhaust
duct
3) Remove the exhaust duct top from the exhaust duct bottom. (1
claw)
4) Remove the damper SW from the exhaust duct top.
Dumper SW (exhaust)
3. Installation direction of the exhaust damper spring.
1) Please install the exhaust damper spring in the direction as
shown in the following picture.
Exhaust
damper
spring
Exhaust
dumper
Lower exhaust duct
Hang the
spring here
Hang the spring
on the hook here
[27] D motor (exhaust)
1. Remove the side cover R, the side cover L, the exhaust cover and
the cabinet. [3] Reference
2. Remove the left/right reinforcing AG and the rear plate. [17] Refer-
ence
3. Remove the AC cord. [15] Reference
4. Remove the bottom plate cover. [21] Reference
5. Remove the bottom plate. [22] Reference
6. Remove the harness from the D motor (exhaust).
7. Remove the screws (2x) which fix the D motor (exhaust) to the ex-
haust duct top.
[28] Fan motor
1. Remove the side cover R, the side cover L, the exhaust cover and
the cabinet. [3] Reference
2. Remove the left/right reinforcing AG and the rear plate. [17] Refer-
ence
3. Remove the AC cord. [15] Reference
4. Remove the bottom plate cover. [21] Reference
5. Remove the bottom plate. [22] Reference
6. Remove the harness from the fan motor.
7. Remove the screws (3x) which fix the fan duct cover to the fan
duct.
Screw
Screw
Screw
Fan motor
Fan duct cover
8. Remove the fan duct cover from the fan duct. (5 claws)
9. Pull out the sirocco fan from the fan motor shaft.
Sirocco fan
10. Remove the screws (2x) which fix the fan motor to the fan duct
cover.
To Next Page
Loading...
