SSC3088AS
37
Fan duct cover
Fan motor
When fitting the sirocco fan to the fan motor, please apply bond
(Cemedine Super-X) to the sirocco fan axle hole. Then, align
the D cut part of the fan motor axle with the D cut part of
the sirocco fan and then insert it.
[29] D motor (SH), damper SW(SH)
1. How to remove the D motor (SH)
1) Remove the side cover R, the side cover L, the exhaust cover
and the cabinet. [3] Reference
2) Remove the left/right reinforcing AG and the rear plate. [17]
Reference
3) Remove the AC cord. [15] Reference
4) Remove the bottom plate cover. [21] Reference
5) Remove the bottom plate. [22] Reference
6) Turn the left side of the main body upward.
7) Remove the engine unit. ●18● Reference
8) Remove the pump tube E from the hole of the intake duct bottom.
9) Remove the intake duct bottom while the sirocco motor (left
and the intake duct cover bottom are attached. (3 screws)
Bottom intake duct cover
Sirocco motor (left)
Lower intake duct
Screw
Screw
Pump tube E
Screw
Lower intake duct
10) Remove the harness from the D motor (SH) and the damper
SW (SH).
11) Remove the slider MTAG from the rear of the heat insulating
plate. (2 screws)
Screw
Screw
Slider MTAG
12) Remove the slider MTAG from the D motor (SH). (2 screws)
Screw
Screw
Damper cam
D motor (SH)
Slider
MTAG
Damper
SW (SH)
Slider
MTAG
2. How to remove the damper SW (SH)
1) Remove the D motor (SH) ( Refer to 1. How to remove the D
motor (SH))
2) Remove the slider MTAG from the damper SW (SH).
3. Precautions on installation of damper cam
To Next Page
Loading...
