SSC3088AS
38
When installing the damper cam, please insert the protruding part
of the damper cam into the slit of the slider. If it is not inserted
rmly, the SH damper embedded in the oven DK will not open/close
normally.
Slider
Slider slit
Damper cam
Protrusion of the damper cam
Protrusion of
the damper cam
Slider slit
4. Precautions on installation of the slider
When installing the slider, please insert the damper shaft between
the upper spring and the lower spring firmly. If it is not inserted
rmly, the SH damper embedded in the oven DK will not open/close
normally.
Upper spring
Lower spring
Slider
Damper shaft
(oven DK embedded parts)
[30] Installation of the spring stopper, upper spring
and lower spring
1. Please install the spring stopper, the upper spring, the lower spring
and the slider as shown in the following picture.
Upper spring
Lower spring
Screw
Screw
Slider
Spring
stopper
Spring Stopper
Upper spring
Lower spring
D motor (SH)
Damper cam
Damper SW (SH)
Slider MTAG
Slider
Damper K (SH)
Screw
Screw
Screw
Screw
[31] Tube pump K, pump motor
1. How to remove the tube pump K
1) Remove the side cover R, the side cover L, the exhaust cover
and the cabinet. [3] Reference
2) Remove the left/right reinforcing AG and the rear plate. [17]
Reference
3) Remove the AC cord. [15] Reference
4) Remove the bottom plate cover. [21] Reference
5) Remove the bottom plate. [22] Reference
6) Remove the pump tube T from the tube joint.
Tube joint
Top tank cover
Tube pump K
Pump tube T
7) Remove the screws (2x) which fasten the tube pump K to the
bottom plate.
Screw
Claw
Drip pan guide L
Bottom plate
8) Remove the claws (2x) of the tube pump K from the bottom
plate.
9) Remove the tube pump K from the bottom plate.
2. How to remove the pump motor
1) Remove the tube pump K from the bottom plate. ( Refer to 1.
How to remove tube pump K)
2) Remove the connector of the pump motor from the hole of the
pump holder.
3) Remove the pump motor from the pump motor MTAG. (2 screws)
To Next Page
Loading...
