06/2/22 WF-5000W(U)2.fm
E-11
TINSEA095AWZZ
Basic Operation
WF-5000W
ENGLISH
Setting the clock (Remote control only)
In this example, the clock is set for the 24-hour (0:00) display.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button.
The time display will appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the or button to display the time. The time
display will appear for about 10 seconds.
Note:
The "CLOCK" will appear or time will flash to confirm the time display when
the AC power supply is restored after a power failure or unplugging the unit. If
incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" is not appear in step
3, step 4 (for selecting the 24-hour or 12-hour display) will be skipped.
To change the 24-hour or 12-hour display:
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press
the
or
button
to select "CLOCK",
and press the MEMORY button.
4
Press the or button to select 24-hour or 12-hour display and
then press the MEMORY button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"AM 0:00" The 12-hour display will appear.
(AM 0:00 - PM 11:59)
5
Press
the
or
button
to adjust the hour and then press the
MEMORY button.
Press
the
or
button
once to advance the time by 1 hour. Hold it
down to advance continuously.
6
Press
the
or
button
to adjust the minutes and then press the
MEMORY button.
Press
the
or
button
once to advance the time by 1 minute. Hold it
down to change the time in 5-minute intervals.
1 Clear all the programmed contents. [Refer to "Clearing all the memory
(reset)" on page 21 for details.]
2 Perform "Setting the clock" from step 1.
To Next Page
Loading...
