Sharp WF-5000W - Tape Record Pause Button

06/2/24 WF-5000W(U)3.fm
TINSEA095AWZZ
Tape Recording
ENGLISH
WF-5000W
E-16
 Recording from the radio
To interrupt recording:
Press the button.
To resume recording, press the same recording button you pressed in step 5.
Other buttons do not allow resuming.
To stop recording:
Press the button.
Beat cancel switch:
If a whistling noise occurs when recording from an MW, SW1 or SW2 station,
set the BEAT CANCEL switch to A, B or C, whichever gives the best reception.
 Recording from the built in microphone
Notes:
 Do not connect anything to the Mixing Mic socket.
 Monitoring of the recording is not possible.
 Recording from the built-in microphone is not in stereo.
 Mixing recording from microphone and tape
Notes:
 Place the microphone about 10-15 cm (4-6") away from the source.
 If the howling occurs, lower the volume or move the microphone as far as
possible from the speaker.
 To record the microphone signals only, load a cassette into the
TAPE 2 cassette compartment, set the FUNCTION to TAPE 2.
Press the button and then press the TAPE 2 button.
Caution:
When not using the microphone, remove the microphone plug from the Mixing
Mic socket.
1
Tune in to the desired station. (See page 12.)
2
Load a cassette into the TAPE 2 cassette compartment with the
side A facing you.
Wind past the leader of the tape, on which recording cannot be per-
formed.
3
Press the ƒƒ
ƒƒ
button to choose one side or both sides.
© … To record on both sides.
é … To record on only one side.
4
Press the button.
Recording will be paused.
5
Press the button to record on side A, or the button on the re-
mote control for side B.
To record on both sides, begin with side A. (If recording is started from
side B, the tape will not switch over to side A.)
1
Press the TAPE (1 2) button until TAPE 2 appears on the display.
2
Load a cassette into the TAPE 2 cassette compartment.
3
Press the ƒƒ
ƒƒ
button to choose one side or both sides.
© … To record on both sides.
é … To record on only one side.
4
Press the button.
Recording will be paused.
5
Press the button again to begin recording on side A or button
for side B.
1
Connect the microphone plug to the Mixing Mic socket.
2 Press the TAPE 1 function.
3 Load a blank tape into the TAPE 2 cassette compartment. Insert a
pre-recorded cassette into the TAPE 1 cassette compartment.
4 Press the button.
5 Press the button of TAPE 1.