Sharp XE-A21S - Page 27

XE-A21S OP X/Z, X1/Z1, X2/Z2 MODE
3 – 5
[JOB END MESSAGE] Case of DATA SAVING (“SALES” or “EJ DATA”):
The messages are printed on both RECEIPT and JOURNAL and recorded in EJ memory.
[JOB END MESSAGE] Case of EJ DATA PRINTING:
The report cancel symbol is printed on both RECEIPT and JOURNAL, but it is not recorded in EJ memory.
The messages except the report cancel symbol are printed on both RECEIPT and JOURNAL and recorded in EJ memory.
[ERROR CODE LIST]
Key Display Print NOTE
1234567890
NORMAL END 0. 0 0 DISPLAY: (INITIAL)
PRINT : STATUS is printed
(The message is fixed in ROM.)
ERROR END E
- Sd - 0 1 DISPLAY: ERROR CODE (2-digits)
PRINT :
SD ERROR MESSAGE and ERROR CODE
(The message is fixed in ROM.)
CANCEL
(CHANGING MODE
KEY)
0. 0 0 DISPLAY: (INITIAL)
PRINT : SD CANCEL MESSAGE
(The message is fixed in ROM.)
POWER OFF E
- Sd - P. O F F DISPLAY: ERROR MESSAGE
PRINT : MESSAGE of POWER OFF
(The message is fixed in ROM.)
123456789012345678901234
***NORMAL END
(Issuing Receipt)
SD ERROR
(Issuing Receipt)
01
SD CANCELED
(Issuing Receipt)
POWER OFF ERROR
AT THE DEVICE CONTROL
SET DATA&TIME AGAIN
(Issuing Receipt)
Key Display Print NOTE
1234567890
NORMAL END 0. 0 0 DISPLAY: (INITIAL)
PRINT : (NON)
ERROR END E
- Sd - 0 1 DISPLAY : ERROR CODE (2-digits)
PRINT : The report cancel symbol, SD ERROR
MESSAGE and ERROR CODE
(The message is fixed in ROM.)
CANCEL
(CHANGING MODE
KEY)
0. 0 0 DISPLAY: (INITIAL)
PRINT : The report cancel symbol and SD
CANCEL MESSAGE
(The message is fixed in ROM.)
POWER OFF E
- Sd - P. O F F DISPLAY: ERROR MESSAGE
PRINT : The report cancel symbol, POWER OFF
ERROR MESSAGE and Notes message
(The message is fixed in ROM.)
123456789012345678901234
(Issuing Receipt)
SD ERROR 01
******
(Issuing Receipt)
SD CANCEL
******
(Issuing Receipt)
POWER OFF ERROR
AT THE DEVICE CONTROL
SET DATA&TIME AGAIN
(Issuing Receipt)
******
No. Description
01 SD card is not find
02 SD CARD PROTECT SWITCH is set “PROTECED”
03
SD CARD WRITTING ERROR (Memory is full) (ECR cannot write the data on SD card.)
04 SD CARD READING ERROR (File is nothing)
05
SD CARD READING ERROR (File data is failed) (ECR cannot read the data on SD card.)
: <<< Reserved >>>
10 Over limitation of data records (Over max record in sales or EJ data.)
: <<< Reserved >>>
99 SD CARD ERROR (Anyhow error except above SD ERROR is occurred when ECR
accesses SD Card.)