11
Now you are ready for sales registration.
Starting sales entries
7
• Preset rates for
%&
You do not have to program these preset prices/amount/rates since they can be entered at
registration.
• Amount entry digit limit for PO amount, RA amount, Manual tax amount
The factory setting makes the maximum amount you can enter. You can program to limit the amount.
• Sentinel - High amount lockout (HALO) for cash in drawer (CID)
• Department group
You can classify departments into a maximum of 9 groups (0 to 9 groups: 0: non-group is assigned).
Sales in each group can later be printed on an individual group total report and full group total report.
• Commission
If you program commission rate (up to two) and classify departments (For PLU/sub-department/
UPC/EANs, their commission rates are tracked by their associated departments.) into commission
groups (0 to 2 groups: 0: non-commission), commission sales and amount in each commission group
can later be printed on an individual and full clerk report.
• Key sequence for AUTO key
• Online time out setting
• Specification of clerk to be trained
Department programming:
The cash register is pre-programmed for departments as follows:
Department: Allow open price entry in normal department (group: 0, commission group: 0), taxable status-
taxable 1 for department 1 to 10, and non taxable for department 11 to 99
When you use department 11 or above, and/or you apply taxable status other than taxable 1 for department 1 to
10, you must change department settings. Please refer to the department programming section for
programming details.
A404_1 06.6.20 3:24 PM Page 11
To Next Page
Loading...
