Sharp XG-MB70X User Manual

-33
Basic Operation
Switching the INPUT
Mode
Select the appropriate input mode for the con-
nected equipment.
Press , , or on the re-
mote control to select the input mode.
••
••
• When pressing
''
''
' or
""
""
" on the projector, input
mode switches in order of :
INPUT 1 INPUT 2 INPUT 3 INPUT 4
Note
• When no signal is received, “NO SIGNAL”
will be displayed. When a signal that the
projector is not preset to receive is received,
“NOT REG.” will be displayed.
• The INPUT mode is not displayed when
“OSD Display” of the “Options1” menu is set
to “OFF”. (See page 51.)
About the INPUT mode
Adjusting the Volume
Press
\\
\\
\/
||
||
| on the projector or VOL
/ on the remote control to ad-
just the volume.
Note
• Pressing or \ will lower the volume.
Pressing or | will raise the volume.
"On-screen Display of INPUT Mode (Example)
Using RGB
Using
Component
INPUT 1/2 mode
INPUT 4 mode
Using S-Video
INPUT 3 mode
Using Video
➝
➝
Used for projecting images from
equipment that sends RGB sig-
nals or component signals con-
nected to the RGB input terminal.
Used for projecting images
from equipment connected to
the VIDEO input terminal.
Used for projecting images
from equipment connected to
the S-VIDEO input terminal.
INPUT 1/
INPUT 2
(RGB/
Component)
INPUT 3
(Video)
INPUT 4
(S-Video)
INPUT buttons
Volume buttons
"On-screen Display
➝
➝
➝
➝
XG-MB70X_E_P29_35.p65 2004.8.6, 11:59 AM33

Sharp XG-MB70X Specifications

General

Brand	Sharp
Model	XG-MB70X
Category	Projector
Language	English