Sharp XG-MB70X User Manual

-67
Appendix
Optional
accessory
Lamp unit
AN-MB70LP
Removing and Installing
the Lamp Unit
Info
• Ensure the lamp unit is removed using the
handle. Ensure the glass surface of the
lamp unit or the inside of the projector are
not touched.
• To avoid injury to yourself and damage to
the lamp, ensure to carefully follow the
steps below.
• Do not loosen other screws except for the
lamp unit cover and lamp unit.
1 Press on the projector or
on the remote control to put
the projector into standby mode.
• Wait until the cooling fan stops.
Warning!
• Do not remove the lamp unit from the
projector right after use. The lamp and
parts around the lamp will be very hot
and may cause burn or injury.
2 Disconnect the power cord.
• Unplug the power cord from the AC
socket.
• Leave the lamp until it has fully cooled
down (about 1 hour).
3 Remove the lamp unit cover.
• Tu rn the projector over. Loosen the user
service screw (1) that secures the lamp
unit cover. Pressing the tab, remove the
lamp unit cover (2).
1
2
User service screw
(for lamp unit cover)
Tab
Tab
AC socket
STANDBY button
XG-MB70X_E_P63_69.p65 2004.8.6, 0:01 PM67

Sharp XG-MB70X Specifications

General

Brand	Sharp
Model	XG-MB70X
Category	Projector
Language	English