Sharp XG-MB70X User Manual

-51
Useful Features
Setting the Video System
The video input system mode is factory preset
to “Auto”; however, a clear picture from the con-
nected audio-visual equipment may not be re-
ceived, depending on the video signal difference.
In that case, switch the video signal.
Menu operation Page 42
Example: “Options1” screen menu for
INPUT 3 (Video) mode
Description of Video Systems
Note
• The video signal can only be set in INPUT 3 or
INPUT 4 mode.
• When the system mode is set to “Auto”, you
may not receive a clear picture due to signal
differences. Should this occur, switch to the
video system of the source signal.
Description
When connected to PAL video equipment.
When connected to SECAM video equipment.
When reproducing NTSC signals in PAL
video equipment.
When connected to NTSC video equipment.
Selectable items
PA L
SECAM
NTSC4.43
NTSC3.58
Setting On-screen Display
This function allows you to turn the on-screen
messages on or off.
Menu operation Page 42
Example: “Options1” screen menu for
INPUT 1 (RGB) mode
Description of “OSD Display” Settings
Description
All On-screen Displays are displayed.
• INPUT/VOLUME/AV MUTE/FREEZE/
AUTO SYNC/ENLARGE/ “An invalid
button has been pressed.” are not
displayed.
• “All buttons on Projector are locked.” is
displayed when the STANDBY button is
pressed while the Keylock function is
active.
Selectable items
(ON)
(OFF)
XG-MB70X_E_P50_62.p65 2004.8.6, 0:00 PM51

Sharp XG-MB70X Specifications

General

Brand	Sharp
Model	XG-MB70X
Category	Projector
Language	English