53
Useful
Features
Menu operation n Page 46
5
Setting the Video System
The video input system mode is factory preset
to “Auto”; however, a clear picture from the
connected audio-visual equipment may not be
received, depending on the Video signal
difference. In that case, switch the Video
signal.
Selectable items
Auto
PAL
SECAM
*NTSC4.43
NTSC3.58
PAL-M
PAL-N
PAL-60
* When reproducing NTSC signals in PAL video
equipment.
The Video signal can only be set in VIDEO or
S-VIDEO mode.
When “Video System” is set to “Auto”, you
may not receive a clear picture due to signal
differences. Should this occur, switch to the
video system of the source signal.
•
•
Note
6
Setting the Video Setup
Selectable
items
Description
0 IRE Sets the black level to 0 IRE.
7.5 IRE Sets the black level to 7.5 IRE.
This function is available for the following
signals.
With COMPUTER/COMPONENT 1 or 2 input:
- 480
I
With S-VIDEO or VIDEO input:
- NTSC3.58
•
Note
7
Selecting the Dynamic Range
An optimum picture may not be displayed if an
HDMI capable device’s output signal type and
the projector’s input signal type do not match.
If this should occur, switch “Dynamic Range”.
Selectable
items
Description
Auto When the black levels of the image
show banding or appear faded, select
the item that results in the best picture
quality. (In most circumstances,
“Standard” should be selected.)
Standard
Enhanced
The Dynamic Range can be selected only
when “HDMI” input mode is selected.
•
Note
8
Checking the Input Signal
This function allows you to check the current
input signal information.
To Next Page
Loading...
Need help?
General
