34
Image Projection (Continued)
Switching the Input Mode
Select the appropriate input mode for the
connected equipment.
Press HDMI, COMPUTER 1/2,
S-VIDEO or VIDEO on the remote
control to select the input mode.
When you select the input mode with
INPUT R/P on the projector:
When R/P is pressed, the Input list
appears. While the Input list is displayed,
follow the procedure below to switch the
input mode.
INPUT list
INPUT Audio
2 MONITOR OUT
HDMI
H
S-VIDEO
S
VIDEO
V
1 COMPUTER1
–Press R/P to select the desired input
mode and then press ENTER.
If ENTER is not pressed, the projector
switches to the selected input mode in a
few seconds.
When no signal is received, “NO SIGNAL” will
be displayed. When non-supported signal is
received, “NOT REG.” is displayed.
•
Note
■
•
•
HDMI, COMPUTER 1/2,
S-VIDEO, VIDEO buttons
To Next Page
Loading...
