ENGLISH
E-20
Radio
- Listening to the Memorised Station -
Listening to the Memorised Station
„
Memorising a station
You can store 30 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead discon-
nection.
„
To recall a memorised station
„
To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
„
To clear a memorised station
1
Perform the steps 1 - 3 in "Listening to the Radio" on
page 19.
2
Press the MEMORY/SET (MEMO-
RY) button to enter the preset tun-
ing saving mode.
3
Within 5 seconds, press the PRE-
SET ( or ) button to select the
preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 5 seconds, press the MEMO-
RY/SET (MEMORY) button to store
that station in memory.
If the "MEMORY" and preset number indicators go out before
the station is memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station previously
memorised will be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
Preset channel Frequency and frequency band
1
Press the PRESET ( or ) button for more than 0.5
seconds.
The preset number will flash and the programmed stations will
be tuned in sequentially, for 5 seconds each.
2
Press the PRESET ( or ) button again when the de-
sired station is located.
1 Recall the memorised station.
2 Whilst it is displayed, press the
MEMORY/SET (MEMORY) but-
ton.
3 Within 5 seconds, press the
CLEAR button on the remote con-
trol.
Listening to the Radio (See page 19.)
To Next Page
Loading...
