Sharp XL-60H

27
RECORDING
1 Press the ON/STAND-BY button to turn the
power on.
2 Press the FUNCTION button until “CD” or “NO
DISC” appears in the display.
3 Load the desired disc.
● Use the APMS function to store the tracks you
want to record in memory. (See page 15.)
4 Load a cassette into the cassette compartment.
5 Press the REC PAUSE button.
● “REC” will flash.
6 Press the 0 button.
To stop recording:
Press the ■ button.
● The tape will stop. When the ■ button is pressed
again, the CD will stop.
● When you press the CD ■ button on the remote
control, the CD and tape will stop.
■ Recording from the built-in radio
1 Tune in to the desired station. (See pages 17 -
18.)
2 Load a cassette into the cassette compartment.
3 Press the REC PAUSE button.
● “REC” will flash.
Note:
● If a whistling noise is heard whilst recording from
an AM station, move the AM loop aerial to a po-
sition where noise is minimised.
4 Press the 0 button.
To stop recording:
Press the ■ button.
■ Erasing a recorded tape
1 Press the FUNCTION button until “TAPE” ap-
pears in the display.
2 Press the REC PAUSE button.
● “REC” will flash.
3 Press the 0 button.
● When recording important selections, be sure
to make a preliminary test to ensure that the
desired material is being properly recorded.
● The ALC (Automatic Record Level Control) cir-
cuit automatically controls the level of the input
signal used for recording.
● The VOLUME, BASS and TREBLE controls may
be adjusted with no effect on the recorded sig-
nal. (Variable Sound Monitor)
● Metal and CrO
2
tapes should not be used for
recording.
■ Recording from the built-in CD player
(CD Synchronised Recording System)
1
2
6
4
5
2
3
4
*60H/70H(SUK)23-27 00.1.5, 11:41 AM27