30
USING EXTERNAL UNITS
■ VIDEO/AUX (Audio signal) input
To listen to or record signals from exter-
nal sources through this unit:
1 Use an RCA lead to connect the desired exter-
nal unit to the VIDEO/AUX sockets.
(red → right channel, white → left channel)
● When using video equipment (Laser Disc player,
VCR), be sure to connect the audio output to this
unit and the video output to a television.
2 Press the ON/STAND-BY button to turn the
power on.
3 Press the FUNCTION button until “AUX” ap-
pears in the display.
4 Operate the external unit.
5 To record the sound from the external unit, per-
form steps 2 - 4 of the “Recording from the built-
in radio” section on page 27.
Note:
● To prevent hum interference, do not place this
unit near television receivers.
External unit
■ CD digital output (optical)
The CD digital signal from this unit can be re-
corded by other DAT or MiniDisc recorders.
1 Remove the DIGITAL OUT socket cover.
2 Use a commercially available digital cable to
connect the unit to the OPTICAL IN socket of a
MiniDisc recorder or a DAT.
3 Put the external unit in the recording mode.
4 Play a CD on this unit.
5 To record the sound from the external unit, per-
form steps 2 - 4 of the “Recording from the built-
in radio” section on page 27.
Note:
● Only CD signals can be output.
Commercially available digital cable
DIGITAL
OUT
*60H/70H(SUK)28-32 00.1.5, 11:41 AM30
To Next Page
Loading...
Need help?
General
