Listening to a CD (CDs)
XL-HP700
1 Press
the
ON/STAND-BY
button
to
turn
the power on.
2 Press
the
CD
button.
I
i~~~~
I
C:
lJ
,-,
.
~J
CI
~~III._IUI
~
Total number of tracks on Total playing time of the
the CD whose number
is
CD whose number
is
flashing flashing
5 Press
the
~
button
to
close
the
disc
tray
1.
6 You can place
discs
on trays 2 - 3
by
following
steps 3 -
5.
7 Press the
~
/ c
button
to
start playback.
• Playback will begin from track 1
on
DISC
1.
After that disc
finishes playing, the next disc will automatically play.
• When the last track
on
the third disc has finished playing,
the CD player will automatically stop.
• When there
is
no CD
in
one of the disc trays
(1
-
3),
the
empty tray will be skipped to the next tray with a CD.
To change other CDs while playing a disc:
Press the ~ button for the disc trays not
in
use.
To interrupt playback:
Press the CD
II
button
on
the remote control.
To resume playback from the same point, press the
~ c button.
To remove the CDs:
While
in
the stop mode, press the desired
~
button.
To
stop
playback:
Press
the.
(CD
.)
button.
5
11
(12 cm) 3
11
(8
cm)
:@
:~
<$>~
4 Place the
CD
on the
disc
tray
1,
label side up.
Be sure to place
an
3
11
(8
cm) CD
in
the middle of the disc tray.
3 Press the
~
button
to
open
the
disc
tray
1.
This system can also play audio CD-R and CD-RW discs, but can-
not record.
Some audio CD-R and CD-RW discs may not be playable due to the
state of disc or the device that was used for recording.
15
To Next Page
Loading...
