Sharp XL-HP700 - Enhancing Your System

XL-HP700 Timer and sleep operation (continued)
• Sleep operation
1 Play back the desired sound source.
2 Press the TIMER/SLEEP button repeatedly untilISLEEP" is
displayed.
To change the sleep time:
While the sleep time is displayed, press the TUNINGITIME
(V
or A) button.
(Maximum: 3 hours - Minimum: 1 minute)
• 3 hours - 5 minutes
--+ 5-minute intervals
• 5 minutes - 1 minute
--+ 1-minute intervals
3 Press the MEMORY/SET button.
4 Your system will enter the power stand-by mode automat-
ically after the preset time has elapsed.
The volume will
be turned down 1 minute before the sleep op-
eration finishes.
To cancel the sleep operation:
Press the ON/STAND-BY button while the sleep timer is set.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button while the sleep timer is set.
The remaining sleep time is displayed for about 5 seconds.
26
Enhancing your system
The connection cord is not included. Purchase a commercially avail-
able cord as shown below.
• Listening to the playback sounds from VCR,
DVD, etc.
1 Use a connection cord to connect the VCR, DVD, etc. to the
VIDEO/AUX IN jacks.
When using video equipment, connect the audio output to this
unit and the video output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the VIDEO/AUX button.
4 Play the connected equipment.
Note:
To prevent noise interference, place this unit away from a television.