XL-HP700
The unit will enter the timer stand-by mode automatically.
To reset
or
change the
timer
setting:
Perform "Timer playback or timer recording" from the beginning.
Note:
When performing timer playback or recording using another unit con-
nected to the VIDEO/AUX
IN
jacks, select "VIDEO/AUX"
in
step
2.
At this time, only this unit will be turned on or enter the power stand-
by mode automatically. It will enter the power stand-by mode when
the end of the recording tape
is
reached
in
timer recording,or 1 hour
after the playback starts
in
timer playback. However, another unit will
not be turned
on
or off.
I-' /II/
,--,
,,
,-,
/III
,--,
,,
/ I "
" I /
I-j:'--IS:-
~H
,,1/
~I
If}
CI
~H
.
c=>
) I '
,-,
/1//
,--,
/ ,
,-,
/1//
,--,
,,
6 Press
the
TUNINGITIME
(V
or
A)
button
to
specify the min-
utes, then press the MEMORY/SET button.
To cancel the
timer
playback/timer recording:
Press the ON/STAND-BY button to turn the power
on.
The illustrations show the timer playback setting.
5 Press the TUNINGITIME
(V
or
A)
button
to
specify the
hour
to
start, then press the MEMORY/SET button.
7 When
the
preset
time
is reached, playback
or
recording will
start.
The volume will increase gradually until
it
reaches the volume
you were listening to before your system entered the timer
stand-by mode.
In
timer
playback:
If you select CD or TAPE, the unit will enter the stand-by mode
after the playback. If you select TUNER, it will enter the stand-
by mode one hour after the timer playback starts.
In
timer
recording:
When the recording tape reaches its end, the timer recording
will end, and the unit will enter the stand-by mode.
25
To Next Page
Loading...
