Sharp XL-HP700

XL-HP700
Recording to a cassette tape
Before recording:
• When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
• SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
• The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
• For recording, use only normal tapes. Do not use metal or
Cr0
2
tapes.
1 Press the ON/STAND-BY button to turn the power on.
I
, 1'-1.-"-/
--, "--'0
::::,
Ie
" ,
:~~~ ,- ~(-~t: 1/ II/ ,.!. _ ;~E,'c,/~I
1~3 I .. !.J .... , j I II ,_...... • ~I
Press the CD button and load the desired disc.
Load a cassette into the cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
2
6 Press one of the DISC SELECT G) - @ (© 1 - © 3) buttons to
start recording.
• To record on both sides, begin on side A. (If recording is
started from side
B, the tape will not switch over to side A.)
• Recording is started from the selected CD. When the play-
back of the last track is finished or the end of the tape is
reached, the CD and the cassette will stop automatically.
• CD playback will start approximately 7 seconds after the
tape starts.
5 Press the e.. button.
Recording will be paused.
3
4
Press the c=) button to choose one side or both sides.
=) To record on both sides.
= To record on only one
side.
• Recording from a CD (CDs)
You can record the desired CD using the DISC SELECT G) - @ (© 1
- © 3) buttons.
Side A
~"
Erase-prevention tab of cassette tapes:
• When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent accidental
recording or erasing.
• To protect the recorded sound, remove
the tab after recording. Cover the tab
hole with adhesive tape to record on the
tape without the tab.
22