Sharp XL-UH3H

E-11
ENGLISH
XL-UH3H
Basic Operation
Setting the clock
In this example, the clock is set for the 24-hour (0:00) display.
To confirm the time display:
Press the CLOCK/TIMER button. The time display will appear for
about 5 seconds.
Notes:
z To reset the clock if the power fails or is unplugged, the unit must
be in the STAND-BY mode.
z "0:00" or time will flash when the AC power supply is restored after
a power failure or unplugging the unit or when reset button is
pressed.
Readjust the clock as follows:
To readjust the clock:
Perform "Setting the clock" from beginning.
PRESET
1 In STAND-BY condition.
2 Press the CLOCK/TIMER button for more than 2 seconds.
3 Within 10 seconds, press the PRESET ( or ) button to
set hour.
4 Press the CLOCK/TIMER button again.
5 Within 10 seconds, press the PRESET ( or ) button to
set minute.
6 Press the CLOCK/TIMER button. The clock is set.