xwzw99u
No. Adjustment Position Adjustment Conditions
Adjustment Method
16 PSIG @AC) 1. R: Connect the oscilloscope between
l Adjust the (R) data to obtain the
TP1031(R) and GND.
waveform shown below.
G: Connect the oscilloscope between
TP1033(G) and GND.
6: Connect the oscilloscope between
TP1034(B) and GND.
2. Press S2001 to call up the ADJ IN mode
and select the following subject.
o*
l
Group: OUTPUT2
Make sure the (G) and (B) waveforms
Subject: VPRG
are quite similar to the (R) waveform.
17 RGB Counter
Adjustment
@AC)
1. Receive the computer input counter
l Using the A and v keys, adjust the
adjustment signal (S-VGA or VGA).
data until there is least flickering on
2. Press S2001 to call up the ADJ IN mode
the screen.
and select the following subject.
Group:
OUTPUT2
Subject: VRCOM(R)
VGCOM(G)
VBCOM(B)
13 RGB gradation 1. Feed the green-only SMPTE pattern sig-
l Adjust the G-GAIN data until the
regeneration
nal.
gradation of the portion @ (95%
adjustment
Group : OUTPUT 1
and 100% white) shown below can
Subject : GBLK
be slightly recognized. Make sure
also that the gradation of the
portion @ (0% and 5% black) is
visible.
19 RGB
Whitebalance
@AC)
1. Receive the 32 steps grayscale signal (S-
. Using the A and ‘I keys, adjust the
VGA or VGA). entire screen looks evenly colorless.
2. Press S2001 to call up the ADJ IN mode
and select the following subject.
Group: RGB
Subject: RBLK(R)
BBLK
27
To Next Page
Loading...
