Sharp YB-S4202AE - Page 10

EN-9
MEMORY SETTING
You can change memory programmes for 20 memory banks. Up to three sequences on any power level can
be programmed for each memory. See cooking sequence chart on page EN-11 for time maximums.
Setting time and power level
Example : Suppose you want to set 4 minutes at 60 % for the 1st sequence and 2 minutes at 30 % for the
2nd sequence for 1 serving in the memory 1.
Step Action Press key Display
1 Choose set mode.
× 2
NUMBER
within 2 sec.
NUMBER will flash on and off .
2 Choose memory number.
NUMBER
3 Touch MANUAL/REPEAT key.
1
CHECK
4 Enter desired cooking time for 1st
sequence.
NUMBER
1
5 Touch SELECT POWER key.
%
NUMBER
1
POWER
POWER will flash on and off.
6 Choose desired power level for 1st
sequence.
%
NUMBER
1
POWER
7 Touch MANUAL/REPEAT key.
8 Enter desired cooking time for 2nd
sequence.
NUMBER
2
9 Touch SELECT POWER key.
NUMBER
2
POWER
%
POWER will flash on and off.
10 Choose desired power level for 2nd
sequence.
NUMBER
2
POWER
%
11 Complete memorizing.
× 2
NOTE:
1. If you want to set memory 11-20, touch the desired NUMBER key twice. Ex. 11=
1
× 2, 12=
2
× 2...
2. If 100% is required, it is not necessary to set the microwave power.
3. If the cooking time exceeds the max. time, the display will show EE9.
4. At Step1, any audible signals will not sound when the SET key is touched first and then an audible signal
will sound when the SET key is touched second.