Sharp YB-S4202AE - Page 11

EN-10
MEMORY CHECK
You can check the information programmed into the memory.
Checking time and power level
Example : Suppose you want to know the information programmed into the memory 1, programmed for 4
minutes at 60% at the 1st sequence and 2 minutes at 30 % at the 2nd sequence, and after that the
memory 13, programmed for 3 minutes at 70 %.
Step Action Press key Display
1 Choose checking mode.
CHECK
NUMBER
2 Choose memory number.
CHECK
POWER
%
NUMBER
1
CHECK
POWER
%
NUMBER
2
Repeat
3 Choose memory number.
× 2
CHECK
POWER
%
NUMBER
1
4 Cancel checking mode.
NOTE:
When
is displayed at step 2 or step 3, the memory is not set.
Setting magnification factor
It is possible to change the magnification factor for double quantity in the memory.
Example : Suppose you want to set the magnification factor to 1.67 for double quantity in memory 1.
Step Action Press key Display
1 Choose set mode.
× 2
NUMBER
within 2 sec.
2 Choose double quantity.
NUMBER
DOUBLE
3 Choose memory number.
NUMBER
DOUBLE
4 Touch MANUAL/REPEAT key.
NUMBER
DOUBLE
5 Enter magnification factor.
NUMBER
DOUBLE
6 Complete memorizing.
× 2
NOTE:
1. In case you want to change the magnification factor it must be set for each key separately.
2. The magnification factor can be set from 0.00 to 9.99.
3. At Step 1, any audible signals will not sound when the SET key is touched first and then an audible signal
will sound when the SET key is touched second.