Sharp YB-S4202AE - Page 13

EN-12
POWER
%
ON
1
POWER
%
ON
1
POWER
%
ON
1
TIME COOKING
MULTIPLE SEQUENCE COOKING
REPEAT COOK
Example : Suppose you want to cook for 2 minutes and 30 seconds at 50 %.
Example : Suppose you want to cook for 5 minutes at 70 % and then continue to cook for 20 minutes at 30 %.
Your oven can remember the last manual programme.
Example : Suppose you want to cook with the last programme, which is programmed for 2 minutes and 30
seconds at 50 %.
Choose the manual cooking.
Choose the repeat cook. Check the last programme.
Choose the manual cooking.
Choose desired power level.
Choose desired power
level for the 1st stage.
Touch SELECT
POWER key.
Enter desired cooking time.
Enter desired cooking
time for the 1st stage.
Start to cook.
Start to cook.
Touch MANUAL/REPEAT key.
Enter desired power level
for the 2nd stage.
Touch SELECT POWER key.
Touch SELECT POWER key.
Check the display.
Check the display.
Enter desired cooking time for the 2nd stage.
Start to cook. Check the display.
NOTE:
1. It is not necessary to touch SELECT POWER key (
) for 100 %.
2. During the cooking, the oven will stop when the door is opened. To restart the cooking, close the door and
press the START key (
). If the START key ( ) is not touched within 1 minute after closing
the door, the programme will be cancelled.
3. If the time you set exceeds a maximum time, the display will show “EE 9”.
Touch STOP/CLEAR key (
) and enter appropriate time.
NOTE:
1. It is not necessary to touch SELECT POWER key (
) for 100 %.
2. When you press START pad, the display will show the total cooking time.
3. During cooking mode, the oven stops when the door is opened, and the programme is canceled if the
START key (
) is not touched within 1 minute after the door is closed.
4. If the time you set exceeds a maximum time,the display will show “EE 9”.
Touch STOP/CLEAR key (
) and enter appropriate time.
POWER
%
ON
1