GAME SPECIFICATIONS AND INSTALLATION
Shelti Eye
2
Manual 13
Attachment to the Floor.
Fasten to the floor according to the appropriate floor “type” instructions A or B.
A. Concrete Floor.
1. Mark two spots on the floor according to the diagram. See Figure 8.
2. Drill two hole at the marked locations, each 12.5mm (1/2”) diameter x 45mm (1-3/4”) deep.
3. Pound in the floor anchors (P) with a hammer until flush with floor.
4. Align the holes in the base of the game with the floor anchors (P). The holes in the base of the game can be located through
the hole in the back of the game.
5. Secure the game with the flat washers (N) and lag bolts (M). See Figure 9.
6. Tighten the lag bolts (M) until flush with the base.
Figure 9 - Floor layout.
To Next Page
Loading...