Shelti Eye 2 SD - A - E2 - Installation

GAME SPECIFICATIONS AND INSTALLATION
Shelti Eye
2
Manual 8
GAME SPECIFICATIONS AND INSTALLATION
SPECIFICATIONS
THIS GAME IS SUITABLE FOR INDOOR USE ONLY.
Height: 86" upright Width: 24"
Weight: 180 lbs. Voltage: 100-240V, 50/60Hz
NOTE: A working area of approximately 6 ft. x 4 ft. with a 7.5 ft (90 inch) ceiling clearance is needed to install this game.
INSTALLATION
1)
Set-up overhead.
2)
Remove the thumb bolts “C” from the cashbox and set them aside within easy
reach.
3)
Slowly and carefully swing the upper section of the game upright, bracing the back
until the game is securely fastened (step 4).
4)
Verify that the wires are not pinched. Place the bolts “C” in the inside top of the
back compartment of the Cougar Eye
2
and thread upward through holes “B” to
secure the upper section of the game. Tighten the bolts.
5)
This game is equipped with an easily replaceable power/line cord which is located
inside the pedestal when shipped. Review top figure on page 12 before proceeding.
6)
Move the game to its operation location without tilting it more than 10 degrees.
Plug power cord into an appropriate outlet.
CAUTION
To ensure safety, it is recommended that the game be secured to the floor
or to the wall using the Stability Assurance Kit provided. See instructions
on the following pages.