Shenzhen MG630 cutting plotter - Installation; Machine Installation and Connections

To Next Page

To Previous Page

4 / 21

3. Installation

3.1 Machine Installation and connections

3.1.1 Place the cutter in a plane and roomy place

3.1.2 Connect the cutting plotter to computer by USB cable or serial cable , or Put U disc

directly to the cutter:.

3.1.3 Check power and voltage, whether it is grounded, do not connect to power until all are in

good condition

WARNING

Make sure machine is grounded, otherwise electric shock

or mechanic default is possibly resulted in.

Don’t use the power source not meeting rating voltage

using the wrong power source may result in fire or

electric shock.

Don’t pull out the plug when

the power is on to avoid

damage to the machine.

Place the machine on a stable

surface, otherwise the

machine may fall therefore

get damaged.