Shenzhen MG630 cutting plotter - Cutting Tool Installation

6 / 21
6 / 21
3.2 Installation cutting tool
CAUTION
Don’t touch the knife top with
your finger prevent injury.
3.2.1: Adjustment the protruding length of the knife top as required for specific cutting
media.
Correct
3.2.2 (1)Loosen the screw Of tool carrier
(2)Assembly the tool with knife into the tool carrier
(3)When the tool is in appropriate position, screw
it and fix the screw.
too long
protruding
length of knife
tip
too short
protruding
length of knife
tip