Sherwood RX-4010R User Manual

Read this Before Operating Your Unit
FOR THE U.S.A. AND
CANADA... oo sicins canta eceess 120V
FOR YOUR SAFETY
Units shipped to the U.S.A and Canada are designed
for operation on 120 volts AC only.
Safety precaution for a Polarized AC plug.
However, some products may be supplied with a non-
polarized plug.
CAUTION: TO PREVENT ELECTRIC SHOCK DO
NOT USE THIS (POLARIZE) PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
FOR THE UNITED KINGDOM .... 240V
FOR YOUR SAFETY
Units shipped to the U.K. are designed for operation
on 240 volts AC only.
The main plug must be removed from the wall socket
prior to any internal examination.
The wires in this-main The wires in this main
lead are coloured in accor- lead must be connected
dance with the following to the terminals in the
code: plug as follows:
Wire colour
1. If a 13-amp plug is used, this must be fitted with
a3-amp fuse.
2. If a3-pin plug with earthing contact is used, no wire
must be connected to the E terminal.
“FOR ADDED SAFETY, WHEN CONNECTING
THE AC MAINS LEAD TO A 3 PIN PLUG
PLEASE USE A 5A FUSE APPROVED BY
ASTA TO BS1362, I.E. CARRIES THE
<A$A> MARK.”
FOR AUSTRALIA AND
EUROPE ............. 220V/230VI240V
FOR YOUR SAFETY
Units shipped to Australia are designed for operation
on 240V AC only.
To ensure safe operation the three-pin plug supplied
must be inserted only into a standard three-pin power
point which is effectively earthed through the normal
household wiring. Extension cords used with the
equipment must be three-core and be correctly wired
to provide connection to earth. Wrongly wired exten-
sion cords are a major cause of fatalities. The fact that
the equipment operates satisfactorily does not imply
that the power point is earthed and that the installation
is completely safe. For your safety, if in any doubt
about the effective earthing of the power point, con-
sult a qualified electrician.
Units shipped to Europe are designed for operation on
220V/230V AC only.
FOR OTHER COUNTRIES .. . 120Vi220V
FOR YOUR SAFETY
Units shipped to countries other than the above coun-
tries are equipped with an AC voltage selector switch
on the rear panel. Refer to the following paragraph for
the proper setting of this switch.
AC VOLTAGE SELECTION
This unit operates on 110-120 volts AC. The AC voltage
selector switch Type A on the rear panel is set to the
voltage that prevails in the area to which the unit is
shipped. Before connecting the power cord to your AC
outlet, make sure that the setting position of this
switch matches your line voltage. If not, it must be set
to your voltage in accordance with the following
direction.
AC voltage selector switch
Type A
Move switch lever to match your line voltage with
a small screwdriver or other pointed tool.

Sherwood RX-4010R Specifications

General

Brand	Sherwood
Model	RX-4010R
Category	Receiver
Language	English