Sherwood RX-4010R User Manual

Rear
Panel
Connection
1. FM INDOOR ANTENNA
Connect
the
supplied
antenna
(the
wire
lead)
to
the
FM
antenna
terminal,
as
shown
in
the
Rear
Panel
Connection
Diagram.
Change
the
position
of
the
antenna
until
you
get
the
best
reception
of
your
favorite
stations.
An
outdoor
FM
antenna
may
be
used
to
further
improve
the
sound
quality
of
the
reception.
Disconnect
the
indoor
antenna
before
replacing
it
with
the
outdoor
one.
2. FM OUTDOOR ANTENNA
This
connector
is
used
for
75
ohms
unbalanced
coaxial
cable
connection.
3. AM LOOP ANTENNA
Tune
in
your
favorite
AM
station
and
position
the
loop
antenna
for
best
reception.
Try
other
stations
and
find
the
position
that
give
best
overall
reception.
When
this
unit
is
mounted
in
a
rack
or
placed
on
a
shelf
with
insufficient
space
behind,
remove
the
loop
antenna
and
hang
it
from
a
wall
in
the
direction
which
gives
best
reception.
If
the
length
of
the
lead
wire
is
too
short,
add
a
lead
wire
of
an
appropriate
length.
AM LOOP ANTENNA SETTING ( )
Stand
and
place
it
on
a
shelf.
Remove
from
the
unit
and
hang
it
from
a
wall.
4. EXTERNAL AM ANTENNA
In ferroconcrete buildings or in areas remote from broadcast stations, the built-in antenna may not prove
adequate. To supplement the built-in antenna, connect 10 to 20 feet of insulated, flexible, single conductor
wire to this terminal, but this wire should be kept away from all speaker cables and power cables and run in
a straight line along a nonmetalic baseboard or under a rug.
5. SYSTEM GROUND TERMINAL
To reduce hum to a minimum, this terminal is used to interconnect the chassis or ground lead of the
Turntable to this Receiver. Connect the ground lead from your Turntable to this terminal.

Sherwood RX-4010R Specifications

General

Brand	Sherwood
Model	RX-4010R
Category	Receiver
Language	English