How to eliminate hissing noise during AM reception on Sherwood Receiver?
If you're experiencing continuous or intermittent hissing noise during AM reception, especially at night, it could be due to noise from motors, fluorescent lamps, or lightning. Keep the receiver away from noise sources. Consider installing an outdoor AM antenna.
How to improve FM reception on Sherwood Stereo Receiver?
If you're experiencing poor FM reception on your Sherwood Stereo Receiver, the first step is to connect an antenna. If an antenna is already connected, try changing its position to find the best reception.
Why can't my Sherwood Stereo Receiver receive stations?
If you cannot receive stations on your Sherwood Stereo Receiver, connect an antenna. If an antenna is already connected, tune in the desired station frequency. You may also need to move the antenna to improve reception and then retry tuning.
Why can't my Sherwood RX-773 receive preset stations?
If you cannot receive preset stations on your Sherwood Stereo Receiver, it may be because an incorrect station frequency was memorized. Memorize the correct station frequency. If the memorized stations are cleared, memorize the stations again.
General| Number of Channels | 2 |
|---|---|
| Speaker Load Impedance | 4 - 16 ohms |
| Power Output | 100 W per channel (8 ohms) |
| Frequency Response | 20 Hz - 20 kHz |
| Input Sensitivity | 200mV (MM) |
| Tuning Range | FM |
| Output | Speaker |
Instructions for connecting FM indoor/outdoor and AM loop antennas for optimal reception.
Connecting various audio sources like CD players, tape decks, MD recorders, and DVD players to the receiver.
Guidelines for connecting up to four pairs of speakers, including polarity and impedance considerations.
Steps for operating external components using the universal remote control, including setup codes.
Guide to entering, searching, and erasing setup codes for various devices.
Programming macro and punch-through functions, learning commands, and erasing data.
How to switch between IR and RF transmission modes for the remote control.
Steps to turn on the receiver and select speaker output combinations.
How to select audio input sources, adjust volume, and mute sound.
Automatically searching for and tuning to radio stations.
Storing preferred radio stations into memory manually.
How to access and activate the ROOM2 mode for independent playback.
Configuring speaker output and selecting the audio source for ROOM2 playback.
To Next Page
