What to do if the serial communication function doesn't work with a USB serial converter on Shimadzu Laboratory Equipment?
First, verify that the correct COM number has been set in the Windows settings. If the issue persists, the driver provided with the USB serial converter may not be set up correctly. Please refer to the Shimadzu website for details on checking/changing the COM number and setting up the driver.
Why doesn't the serial communication function work after rebooting the PC with Shimadzu AP224W?
The serial communication function cannot be used if Balance Keys has not been started up. For details on Balance Keys, refer to the Shimadzu website.
What to do if the cells are not transferred when entering data on Excel with Shimadzu AP224W Laboratory Equipment?
This issue may occur if Excel is not set to move cells after pressing the Enter key. To resolve this, in Excel, go to File > Options > Advanced Settings, and enable 'Move cell after pressing the [Enter] key.' Also, ensure that the Japanese conversion function in Windows is set to OFF, as this can interfere with data transfer.
Why do operations sometimes seem strange with Shimadzu AP224W Laboratory Equipment?
Strange operations can occur if the communication speed is set too slow in Balance Keys, depending on your PC's performance. Adjust the communication speed to align with your PC's capabilities. Also, if the interval for transmitting data from the balance is too short, it can cause malfunctions. Ensure data is transmitted after it has been displayed on the screen and avoid using the continuous output function. Additionally, ensure nothing is touching the PC keyboard or mouse when data is being transmitted from the balance.
What to do if garbled text is loaded onto the PC from Shimadzu Laboratory Equipment?
If garbled text appears on your PC, the serial communication function settings on either the balance or the PC are likely incorrect. Reset these settings to resolve the issue.
Covers safety guidelines for balance usage and installation environments.
Safety measures for installation work and general balance operations.
Warnings about hazards related to unauthorized repairs or modifications.
Detailed steps for powering on the balance, including auto calibration.
Step-by-step guide for performing standard weight measurements.
How to select and change the active measurement mode.
Performing calibration and tests using the balance's internal weights.
Performing calibration and tests using external calibration weights.
Detailed steps for performing piece counting measurements.
Detailed steps for performing percent measurement.
Performing measurements to reduce fluctuations using averaging.
Detailed steps for measuring the specific gravity of solid samples.
Detailed steps for measuring the density of liquid samples.
Using add-on mode for formulating large quantities of fine samples.
Using the formulation mode for preparing multiple samples.
Using recipes to prepare samples, especially for compounding medicines.
Preparing buffer solutions using pre-registered recipes.
Supporting sample collection and preparation for analysis.
Calculating statistics like average, standard deviation from measurement data.
Comparing weighing values against target values and displaying status.
Judging sample weights as pass or fail against set limits.
Setting and evaluating the minimum weighing value for reliable measurements.
A guide to identifying and resolving common balance problems and error messages.
Lists potential error messages, their causes, and recovery steps.
Detailed technical specifications for the W-AD Series balances.
Detailed technical specifications for the W Series balances.
Detailed technical specifications for the X Series balances.
Detailed technical specifications for the Y Series balances.
General| Capacity | 220 g |
|---|---|
| Readability | 0.1 mg |
| Repeatability (Standard Deviation) | 0.1 mg |
| Linearity | ±0.2 mg |
| Interface | RS-232C |
| Type | Analytical Balance |
| Display | LCD |
| Power Supply | AC adapter |
| Operating Temperature | 5 °C to 40 °C |
| Pan Size | ø80mm |
| Calibration | Internal calibration |
| Power Requirements | AC 100-240V, 50/60 Hz |
| Operating Humidity | 85 %RH or less (no condensation) |
To Next Page