Need help?Do you have a question about the Shimadzu LC-10 and is the answer not in the manual?
General| Pressure Range | 0 to 40 MPa |
|---|---|
| Category | Laboratory Equipment |
| Pump Type | Reciprocating |
| Flow Rate Range | 0.001 to 9.999 mL/min |
| Maximum Pressure | 40 MPa |
| Gradient System | Binary or Quaternary |
| Detector Type | UV-VIS |
| Detector | SPD-10A |
| Wavelength Range | 190 to 700 nm |
| Autosampler | SIL-10A |
| Injection Volume | 1 to 100 µL |
| Column Oven | CTO-10A |
| Degasser | DGU-14A |
| Operating Temperature | 4 to 40°C |
| Dimensions | Varies by module |
| Weight | Varies by module |
| Power Requirements | 50/60 Hz |
Details the minimum firmware versions required for various Shimadzu LC-10/20 system components.
Explains how to establish serial and LAN communication between the system controller and the computer.
Guides the user through installing the Clarity software from the CD-ROM.
Details how to configure the Shimadzu LC-10/20 System and its modules within the Clarity software.
Configures and controls the Shimadzu LC-10/20 System pumps, including gradient setup.
Covers configuration and operation of Shimadzu LC-10/20 detectors, including acquisition and monitoring.
Covers configuration and operation of autosamplers for automated sample injection.
Covers configuration and operation of the PDA detector, including spectral acquisition.
Covers configuration and operation of the thermostat (column oven).
To Next Page