4 Using the control module Clarity Controls
4.5.3 Method Setup - Thermostat - Time Program
Fig 51: Method Setup - Thermostat - Time Program
Time Table
The initial analysis settings defined on the Thermostat sub-tab can be
changed during the analysis by events programmed in the Time Table.
Possible events are:
Thermostat Off - At specified time, switches of the thermostat.
Temperature - Changes the temperature to the specified value in one
step.
Linear Temperature - Changes the temperature using the temperature
ramp.
Left Valve - Changes the position of the left valve.
Right Valve - Changes the position of the right valve.
- 67 -
To Next Page
Loading...
