Shimadzu LC-10 User Manual

4 Using the control module Clarity Controls
4.3 Autosampler
The autosamplers used with the Shimadzu LC-10/20 System allow for
automated injection of samples. This can only be performed from the
Sequence window, not from the Single Analysis dialog (where it is
impossible to specify from which position the injection will be performed).
4.3.1 Shimadzu LC-10/20 System Setup - Autosampler
Some options may be missing or shaded depending on the type of the
autosampler installed.
Fig 34: Shimadzu LC-10/20 System Setup - Autosampler
Name
Sets the name of the autosampler.
Sample Loop Size
Defines the volume of the injector loop. Some parameters are predefined,
but any whole number in certain range can be entered. The range
depends on the type of the autosampler.
Injection Triggered By External Device
Sets whether the injection will be performed only after the external start
contact on the controller is closed.
Skip Missing Vial
Defines whether the missing vial in the sequence measurement should be
skipped. Otherwise, the sequence would be stopped when encountering
the missing vial.
Sample Cooler Installed
Defines whether the tray cooler is installed.
- 45 -

Shimadzu LC-10 Specifications

General

Brand	Shimadzu
Model	LC-10
Category	Laboratory Equipment
Language	English