Shimadzu LC-10/20 System 2 Requirements
2 Requirements
l Clarity installation CD ROM with LC control module (p/n A24) allowed.
Other parts of the system may need other modules or extensions, namely
the autosampler will need the AS control module (p/n A26) and the PDA
Detector will need the PDA extension (p/n A29) to operate.
l Supported Shimadzu system controller (see the full list of supported
controllers in the chapter "Shimadzu LC-10/20 System" on pg 1.). The
controller is needed even for the control of standalone PDA detector.
l Free serial port in the PC.
Note: Modern computers usually have only 1 (if any) serial (COM) port installed.
To use more devices requiring the RS232 port, the MultiCOM adapter
(p/n MC01) is available.
l Standard RS232-compliant cross DB9F-DB9F serial cable (p/n SK01) or
cross LAN cable (p/n SK08) in case of LC-20 system.
Note: Cables are not part of Clarity Control Module. It is strongly
recommended to order required cables together with the Control Module.
l SCSI card for use of the SPD-M10Avp PDA detector. SPD-M20A PDA
detector uses LAN communication.
Caution: It is recommended to use Adaptec SCSIcards. Drivers for Adaptec's
cards are located on Clarity installation CD ROM in directory HW_
DRIVERS\ASPI2 . Read the README.TXT file before you install the
drivers.
Caution: SPD-M10Avp PDA detector is not supported on 64-bit Windows.
- 3 -
To Next Page
Loading...
Need help?
General
