Shimadzu LC-10 - Method Setup - as

To Next Page

To Previous Page

4 Using the control module Clarity Controls

4.3.3 Method Setup - AS - Time Program

Fig 38: Method Setup - AS - Time Program

Time Table

It is possible to set events to be performed during the analysis run based

on the analysis time, namely the Inject, Rinse and Start Pretreatment

actions.

Note: The time needed to perform the Rinse operation is longer than 1 minute,

for exact duration it is necessary to test it in the given configuration.

- 51 -

Shimadzu LC-10 - Method Setup - as - Time Program