Shimadzu LC-10 User Manual

Shimadzu LC-10/20 System Table of Contents
Contents
1 Shimadzu LC-10/20 System 1
2 Requirements 3
2.1 Minimal version of device firmware required 4
3 Installation Procedure 5
3.1 Shimadzu LC-10/20 System communication 5
3.2 Software Installation 7
3.3 Clarity Configuration 8
3.4 Shimadzu LC-10/20 System Setup 11
3.4.1 Shimadzu LC-10/20 System Setup - Setup 12
3.4.2 Shimadzu LC-10/20 System Setup - Controller 14
4 Using the control module 16
4.1 Pump 17
4.1.1 Shimadzu LC-10/20 System Setup - Pump 17
4.1.2 Method Setup - LC Gradient 19
4.1.2.1 Gradient Options 21
4.1.3 Method Setup - LC 23
4.1.4 Method Setup - Advanced 26
4.1.5 Device Monitor 27
4.1.6 Report Setup 29
4.2 Detector 30
4.2.1 Shimadzu LC-10/20 System Setup - Detector 30
4.2.2 Method Setup - Acquisition - Detector 32
4.2.2.1 Method Setup - Acquisition - RF Detector 34
4.2.2.2 Method Setup - Acquisition - RID Detector 36
4.2.3 Method Setup - Acquisition - Time Program 38
4.2.4 Method Setup - Acquisition - Analog Output 40
4.2.5 Device Monitor 41
4.2.6 Report Setup 43
4.3 Autosampler 45
4.3.1 Shimadzu LC-10/20 System Setup - Autosampler 45
4.3.2 Method Setup - AS - Sampler 47
4.3.2.1 Method Setup - AS - Sampler (SIL-10Axl) 49
4.3.2.2 Method Setup - AS - Sampler (SIL-10AF) 50
4.3.3 Method Setup - AS - Time Program 51
4.3.4 Method Setup - AS - Pretreatment 52
4.3.5 Device Monitor - Shimadzu LC-10/20 System 56
4.3.6 Report Setup 57
4.4 PDA 58
4.4.1 Shimadzu LC-10/20 System Setup - PDA Detector 58
4.4.2 Method Setup - PDA 60
4.4.3 Method Setup - Acquisition 62
4.4.4 Device Monitor 63
4.4.5 Report Setup 64
4.5 Thermostat 65
- i -

Shimadzu LC-10 Specifications

General

Brand	Shimadzu
Model	LC-10
Category	Laboratory Equipment
Language	English